SLIM100 - Replacement of air filters
3479235800 - filter from the fan side
3247833400 - PE filter from other side (not implemented to all charger)
1. Turn OFF the external power supply and ensure that there is no voltage within the charger.
2. Check that no vehicle is plugged into any of the charging points, and there is no risk of voltage backfeed.
3. Gently open right-side doors according to picture below.
4. Slightly pull the bottom part of the door towards you, then lift up to avoid damaging the door seals.
Figure 1. From the bottom, opening the doors
5. Unplug the 3 chassis ground wires from the side panel (only 2 are visible in the following images shown).
Figure 2. Grounding wiring
6. Release filter cover with two screws, use Torx30 bit, replace the new air filter and fix the filter cover in position with two screws, use Torx30 bit.
Figure 3. Air filter and screws (Torx30 head)
7. Release the fan cover and replace the filter.
Figure 4. Fan side filter
By using Delta Electronics (Netherlands) B.V. and affiliates website and its technical information, you agree to be bound by the terms of this warranty disclaimer.

